Our Products

Telephone: 800-621-4274 Facsimile: 800-640-8044 DoD Cage Code: 7DVG8

54 Concourse Way Greer, South Carolina 29650

Main Types of Taps

HAND TAPS (SHORT MACHINE)

This regular type is the basic tap designed as a general purpose tool for hand and machine operation.

As this basic tap will give acceptable performance in most materials and for short production runs, it is usually the most economical tap to use. However, it performs best in materials where the cutting action results in chips which break up readily and do not present problems of chip disposal.

The regular hand tap has four flutes in sizes larger than ¼ inch diameter. These taps may not be suitable because of inadequate chip space when deep or blind holes have to be tapped in soft stringy materials. This applies particularly to the coarser pitch threads such as BSW and UNC.

If a gun tap or spiral fluted tap cannot be used, a three fluted tap which permits extra chip space, is recommended.

If you have any questions, please do not hesitate to contact us or call 800-621-4274.

PIPE TAPS

Pipe taps are supplied with PARALLEL threads or with TAPER threads.

These taps are shorter than a similar size of regular hand tap, but the design features are the same. They are suitable for hand or machine use.

If you have any questions, please do not hesitate to contact us or call 800-621-4274.

GUN NOSE TAPS. (SPIRAL POINT) FOR MACHINE USE ONLY

Gun nose taps have straight flutes supplemented by angular cutting faces at the point. These faces cut with a shearing action which propels the chips ahead of the tap leaving the flutes clear for the free flow of coolant to the point.

Primarily designed for use in through holes, these taps can be used in blind holes providing that there is ample clearance beyond the threaded section to accommodate the chips. The advantages of a gun nose tap are, the shearing action of the angular cutting faces which produce a fine finish on the threads and, shallower flutes which permit a stronger cross section throughout the tap.

 

SPIRAL FLUTE TAPS. FOR MACHINE USE ONLY

These taps, designed primarily for machine tapping of blind holes, are used to the best advantage in materials which produce long stringy chips. The shearing action provided by the spiral flutes produces a better finish on difficult to machine metals and causes the chips to be drawn back, eliminating clogging at the cutting chamfer.

If you have any questions, please do not hesitate to contact us or call 800-621-4274.

SERIAL TAPS

Serial taps comprise of one or more undersized roughing taps which remove most of the material before final sizing with a finishing tap.

Some reasons for using serial taps are:

    (a) The roughness of the material being tapped.

    (b) The amount of material to be removed could cause swarf choking with a single tap.

    (c) The very small tolerance on pitch diameter.

    (d) An extremely good finish required.

  If you have any questions, please do not hesitate to contact us or call 800-621-4274.

FLUTELESS (ROLL) TAPS. (Fluteless Chipless Tapping)
These taps are designed for machine tapping in ductile materials, “Fluteless” taps have no flutes or cutting faces, but have special roll forming lobes with a circular lands and have long or short taper leads for through or blind holes.

If you have any questions, please do not hesitate to contact us or call 800-621-4274.